Power Plants

In Power Plants, moisture present in the air, accelerates the rate of corrosion leading to Deterioration and malfunctioning of expensive equipment like Turbines, Power Generators, boilers, condensers etc.

General Recommendations

Relative Humidity during Power Plant Standby should be maintained at 15%-30% RH at 24°C (75°F) and during operation at less than 35% RH at ambient temperature to minimize the loss due to corrosion.

Our Solutions

In the Power Industry, expensive equipment like Turbines, Power Generators, Boilers, condensers etc. begin to rust and corrode while in storage or during plant shutdown or even when in operation due to moisture present in the air. Moisture accelerates the rate of corrosion leading to

• Deterioration of parts and components
• Malfunctioning
• Decrease in life of turbines etc.

Power Plant Lay Up

There may be several reasons why some power generating equipment or even, the whole power plant has to be idled or shutdown temporarily or for extended period viz.

• For maintenance or repair
• Due to excess capacity
• As Standby in case of break down
• Partial shut down due to excess capacity
• Hold until start up
• ‘Extended cold standby” (ECS)

All equipment, when not in operation, must be preserved in the ‘As Left’ condition till there is a need to activate them. When needed, they should be capable of going ‘On-Line’ immediately.

Controlling Corrosion…. through Dehumidification

Rate of corrosion accelerates, when Relative Humidity crosses the critical level of 40%. Above this level industrial pollutants, like Sulphur-Di-Oxide, also, enhance the corrosion rate as the Corrosion is faster when surfaces are exposed to polluted air in combination with high relative humidity.

Hence, if the relative humidity of the area where expensive equipment is stored can be restricted to below 40% then all equipments like generator, turbines and their components can be maintained in well-preserved condition for immediate activation, whenever required.

Dehumidification involves drying the air by actually removing moisture from it. Removal of moisture from the Storage area lowers the relative humidity of the area effectively arresting corrosion and microbial growth. During turbine storage proper dehumidification, ensures minimum deterioration of all internal systems.

Power plants idled for maintenance or repair can be effectively protected from corrosion, by blowing dehumidified air through the steam side as well the generator winding. Dehumidified air keeps non-nuclear components as boilers, condensers, turbines, rust free when the nuclear plant is shut down for refueling-a process that can take up to a whole year.

In case of fossil fuel power station, layup can be due to furnace or boiler repair or less expensive power becoming available, from alternate source, during such periods – a flow of dehumidified air in the facility prevents rusting and other harmful moisture related problem.